Dimplex DWF1203 Manuale di Servizio

Service ManualModelDWF1203Part Number69084901007400580000R00In keeping with our policy of continuous product development, we reserve the right to make

10 www.dimplex.comCIRCUIT BOARD REPLACEMENT REMOTE CONTROL RECEIVER or LED DRIVER BOARD Tools Required: Philips head screwdr

11place. (Figure 8)Inside the lower cavity, locate the Flicker Motor and 11. the Flicker Rod. The Flicker Rod can be removed by re-moving the brackets

12 www.dimplex.comcenter of the back of the unit. (Figure 7)Lay unit on its back and remove the remaining nine (9) 7. screws

13 CAUTION: Ensure that the remote control wire antenna is placed so that it is not caught between any of the screws or sheets of metal.! NOTE: Be su

14 www.dimplex.comPROBLEM CAUSE SOLUTIONGeneralCircuit breaker trips or fuse blows when unit is turned onShort in unit wiring

15PROBLEM CAUSE SOLUTIONHeaterHeater is not turning Off Improper operation Refer to Operation SectionDefective Heater On/Off Switch Defective Heater O

2 www.dimplex.comAlways use a qualied technician or service agency to repair this replace.! NOTE: Procedures and technique

3Remote ControlThe replace is supplied with a radio frequency remote control. This remote control has a range of approximately 50 feet (15.25 m), it

4 www.dimplex.comMAINTENANCE WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of

5EXPLODED PARTS DIAGRAMREPLACEMENT PARTS LISTHeater Assembly (with Cutout)1. ... 2200490800RPFront Glass2. . . . . . . . . . . . . . . . .

6 www.dimplex.comWIRING DIAGRAMP1P2

7SWITCH REPLACEMENTTools Required: Philips head screwdriverFlat head screwdriverNeedle-nose pliers WARNING: If the replace was operating prior to

8 www.dimplex.comOn either side of the rebox, remove the retaining 1. screws and carefully remove the glass assembly from th

9(7) screws around the outside of the end panel. (Figure 5)Lay unit on its back and remove the remaining nine (9) 6. screws from the end panel.Remove