Dimplex DF3015 Manuale di Servizio Scaricare il pdf (Pagina 10)

6. Pull the front edge

of the plastic Ember

Bed or plastic grate

up and forward until

the rear tab releases

from the ledge

located at the bottom

of the Mirror

(Figure 6).

IMPORTANT:Only

handle the Log Set

Assembly by the Ember Bed or plastic grate.

NOTE:Log Set Assembly ts tightly into rebox, some

force may be necessary to remove.

7. Disconnect LED harness (Figure 7).

8. Set Log Set Assembly in front of rebox.

MirrorReplacement

If the replace was operating prior to servicing allow at least

ve (5) minutes for light bulbs and heating element to cool off

to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or

cleaning to reduce the risk of electric shock or damage to

persons.

ReplacementProcedure

1. Slide rebox out of mantel.

2. Lay unit on it’s back for safe removal of Front Glass.

3. Remove four (4) Phillips screws from the right side of

Trim (Figure 4, page 7).

4. Remove Trim.

5. Slide glass to right side of replace to remove (Figure 4).

CAUTION:Even though the glass is safety glass it may

break if bumped, struck of dropped. Care must be

taken when handling the glass.

6. Pull the front edge of the plastic Ember Bed or plastic

grate up and forward until the rear tab releases from

the ledge located at the bottom of the Mirror (Figure 6).

IMPORTANT:Only handle the Log Set Assembly by the

Ember Bed or plastic grate.

NOTE:Log Set Assembly ts tightly into rebox, some

force may be necessary to remove.

7. Loosen but do not remove the two (2) Philips screws that

clamp the Mirror in place, and swivel down so that the

clamp clears the edge of the Mirror (Figure 8).

Mirror

Clamp

Figure 8

Back

Ledge

Log

Ember Bed

Rear

Tab

Front

Edge

Side Section

Figure 6

8. Push the Mirror out from behind to clear the frame and

remove.

9. Insert replacement Mirror top end rst and lay the bottom

end gently in the bottom track of the frame.

10. Tighten clamps back into place and re-assemble rebox

in reverse order as described above.

Figure 7

Log Set Assembly

LED Wire

Harness

Lower

Bulbs (3)

Plastic

Bushing

Flicker Rod

 NOTE:Lower bulbs are accessible without moving

Flicker Rod. If additional room is required, twist Plastic

Bushing as shown in inset of Figure 7 until it allows the

Flicker Rod to slide up from bracket. The spring on the

opposite end of the Flicker Rod is exible enough to

allow Flicker Rod to be turned away, allowing greater

access to bulbs.

9. Unscrew bulbs counter clockwise to remove.

10. Insert new bulbs and screw in clockwise.

11. Move Flicker Rod back into place (if applicable) and

ensure Plastic Bushing is turned to lock rod in place.

14. Reconnect LED harness.

15. Install the Log Set Assembly by placing the front, bottom

edge of the Ember Bed in the track behind the control

panel. Once in place, push down on the back edge of

the Ember Bed until the rear tab snaps into place under

the Mirror (Figure 6).

16. Lay unit on it’s back and slide Front Glass back into

position and attach Trim.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Commenti su questo manuale

Nessun commento

Dimplex DF3015 Manuale di Servizio Pagina 10

Commenti su questo manuale

Prodotti e manuali riguardandi Camini Dimplex DF3015